The clean solution with many applications.
A hygienic environment is the foundation for stable grow results: Purolyt disinfectant concentrate helps you keep your plants’ surroundings free from unwanted microorganisms. This creates clean conditions in grow tents, greenhouses, and work areas – even at high temperatures and humidity.
Purolyt is a disinfectant concentrate based on hypochlorous acid (HOCl) and is produced in a resource-efficient electrochemical process from water + salt + electricity. It is diluted according to the specific application and is suitable for room air, surfaces/equipment, water/liquids, and inert substrates.
Application & Dosage
Important: For all applications, observe the information on the manufacturer’s label/data sheet. The following dosages are typical manufacturer recommendations for the respective areas of use.
| Application | Dosage / Dilution | Practical Notes |
|---|---|---|
| Air / Room (Spraying or Fogging) | 1:50 (20 ml per 1 liter of water) | Use purified water for the solution (e.g. distilled, deionized, or reverse osmosis water). Cold fogging is recommended for optimal distribution, especially for room air treatment. |
| Surfaces / Equipment / System Components | 1:50 (20 ml per 1 liter of water) | Pre-clean surfaces mechanically. Fully wet all areas. Allow to act for 3–6 minutes depending on contamination. Parts with cavities can be immersed; pipes and hoses can be flushed. |
|
Water & Other Liquids (e.g. water tanks, water-bearing systems, air-conditioning systems) |
Preventive: 5–10 ml per 10 liters In case of contamination: 20–40 ml per 10 liters |
Below 23 °C, the lower dosage is usually sufficient once per week; above 23 °C, the higher dosage is usually recommended twice per week. When using organic fertilizers, enzymes, or microorganisms in hydro systems, wait 2 hours after water disinfection. |
| Inert Substrates (Recycling) | 1:100 (10 ml per 1 liter of water) | Completely soak the substrate and let it rest for 24 hours. Suitable for inert substrates (e.g. rockwool, expanded clay, perlite). |
Example: Hygiene routine (guideline)
If you spray/fog regularly: ideally apply towards the end of the lighting cycle and avoid direct sunlight/UV exposure.
Ingredients / Technical data
- Active substance: Active chlorine released from hypochlorous acid (HOCl) (< 1%)
- pH value (20 °C): ≤ 6
- Biocidal product types (SDS): Product type 2 / 3 / 4
- BAuA registration number: N-106687
Storage
- Always close the container tightly after removal.
- Store in a cool and well-ventilated place; recommended storage temperature: approx. 20 °C.
- Protect from light/UV, heat, and moisture.
Hazard information
Purolyt is not classified as hazardous within the meaning of Regulation (EC) No. 1272/2008 [CLP].
Use biocidal products with care.
Always read the label and product information before use.
Keep out of reach of children.
Do not mix with other cleaning, bleaching, or disinfecting agents.
Do not apply undiluted to sensitive materials (if in doubt, test material compatibility in an inconspicuous area).
| Size: | 1 Liter |
| Content: | 1,00 l |
All reviews:
